Skip to main content
Electrical Engineering

Return to Question

replaced http://electronics.stackexchange.com/ with https://electronics.stackexchange.com/
Source Link
Community Bot
Community Bot
  • 1

I have two Xbee S6 wifi modules (XB24-WFSIT-001 rev G), DF robot xbee atapter V2 and sparkfun XBee Explorer USB.

I'm able to upload firmware to any of them (version 102D for example) using sparkfun adapter,(not df robot's one), but X-CTU can't set AT parameters after upload. I use this adapter with other xbees and it works fine.

Also it's not possible to enter command mode using +++ sequence, module just ignores it.

I have tried Xbee Factory -Hardware reset without serial communicationXbee Factory -Hardware reset without serial communication and it didn't help.

I have two Xbee S6 wifi modules (XB24-WFSIT-001 rev G), DF robot xbee atapter V2 and sparkfun XBee Explorer USB.

I'm able to upload firmware to any of them (version 102D for example) using sparkfun adapter,(not df robot's one), but X-CTU can't set AT parameters after upload. I use this adapter with other xbees and it works fine.

Also it's not possible to enter command mode using +++ sequence, module just ignores it.

I have tried Xbee Factory -Hardware reset without serial communication and it didn't help.

I have two Xbee S6 wifi modules (XB24-WFSIT-001 rev G), DF robot xbee atapter V2 and sparkfun XBee Explorer USB.

I'm able to upload firmware to any of them (version 102D for example) using sparkfun adapter,(not df robot's one), but X-CTU can't set AT parameters after upload. I use this adapter with other xbees and it works fine.

Also it's not possible to enter command mode using +++ sequence, module just ignores it.

I have tried Xbee Factory -Hardware reset without serial communication and it didn't help.

Source Link
ETK
ETK
  • 65
  • 6

xbee doesn't respond to command sequence

I have two Xbee S6 wifi modules (XB24-WFSIT-001 rev G), DF robot xbee atapter V2 and sparkfun XBee Explorer USB.

I'm able to upload firmware to any of them (version 102D for example) using sparkfun adapter,(not df robot's one), but X-CTU can't set AT parameters after upload. I use this adapter with other xbees and it works fine.

Also it's not possible to enter command mode using +++ sequence, module just ignores it.

I have tried Xbee Factory -Hardware reset without serial communication and it didn't help.