All Questions
8 questions
1
vote
0
answers
22
views
Will the power output (4.5W?) of a standard USB-A 3.1 port cause any issues with a 7.5-watt NVMe SSD in a USB-A enclosure(RTL9210B)? [closed]
(An SSD in a USB-A to NVMe enclosure (RTL9210B bridge))
Will the power output (4.5W?) of a standard USB-A 3.1 port cause any issues with a 7.5-watt NVMe SSD in a USB-A enclosure(RTL9210B)?
Or will the ...
- 11
2
votes
1
answer
749
views
Reading EEPROM memory (Winbond W25M02GV) with FT4222H USB bridge
I would like to read an EEPROM Memory (SPI Flash Winbond) using an FTDI USB/SPI bridge (FT4222H).
I developed a c++ application that connects to the FTDI and reads data from the memory(and using the ...
- 21
0
votes
1
answer
379
views
USB to UART Bridge IC question
I have a few basic questions regarding this USB to UART bridge IC
My questions are just from the hardware perspective. I have little to no software knowledge. So please bear with me and help me ...
user220456
2
votes
2
answers
929
views
Is it possible to connect a peripheral mouse to the USB side of a USB/UART bridge that is controlled by a CP2103 chip already on an FPGA board? [duplicate]
As the title states I want to connect a USB mouse to the USB port on a USB/UART bridge. I want to determine if it is possible to communicate with the mouse using serial commands on the FPGA board then ...
- 181
2
votes
2
answers
2k
views
MCP2200 doesn't work everytime
I have designed a PCB which has LM1117 (for 3.3V), Micro USB connector, MCP2200 usb-to-uart ...
- 962
0
votes
1
answer
1k
views
Connect two embedded devices with USB host with Ethernet?
I need to connect two microprocessors that only have USB host, not OTG or client.
Obviously I would like to connect them as directly and quickly (ie 10's of Mbit up to 100) as possible. A USB to ...
1
vote
2
answers
1k
views
Is it possible to construct a USB to UART bridge using MAX232 or TUSB3410 IC?
I am trying to build my own Arduino board. But for connecting it with a PC a USB to UART bridge was required. Even though I can buy it from sparkfun, I wanted to build my own bridge using some sample ...
- 175
5
votes
2
answers
8k
views
Configuring baud of USB-Serial bridge
I hope I'm asking this in the right place, I didn't know if it should go on stack exchange or super user instead.
Problem Summary:
I need to configure the baud rate of a USB to Serial bridge device.
...
- 5,134