Skip to main content

All Questions

Filter by
Sorted by
Tagged with
0 votes
1 answer
164 views

Temperature compensation equation?

I'm looking for the correct temperature compensation equation to use on our project. We are measuring the output of a detector who's signal is very sensitive to temperature drift. Any external ...
Conor's user avatar
  • 1
0 votes
1 answer
88 views

Maths behing implementing temperature compensation on a signal

I have a fluid pressure sensor (blue line) whose measurements are affected by outdoor temperature (yellow line). So there is a 12 hours cyclic component (day/night) in my pressure measurements. How ...
Vinlar's user avatar
  • 115
2 votes
2 answers
2k views

Three-wire load cell and HX711 weight compensation

In my project I use a 3-wire load cell (like this (3-wire 50kg), but mine were purchased from eBay) and an HX711 for weighing. My wiring is like this (but I use an Arduino Mini Pro 3.3 V): Apparently ...
Peter Bašista's user avatar
2 votes
2 answers
943 views

Crystal compensation for temp and voltage

Introduction I'm toying with the design for a fail-safe wall clock controlled by multiple 32.768kHz crystal oscillators. I'm currently reading about compensation. Compensator from literature From ...
Reinderien's user avatar
  • 3,259
10 votes
3 answers
5k views

Need for Temperature Compensation of Current Mirror

I am currently learning about current mirror configurations. I have made two of them so far. Both of them worked as desired but, when heated or cooled, the current through the right side (the side ...
lucenzo97's user avatar
  • 2,452
-2 votes
1 answer
130 views

APD temperature variation

I know that the gain (M factor) of APD (Avalance Photo Diode) changes with temperature at a give reverse bias voltage, therefore, we need to a compensation either using a thermoelectric cooler or a ...
HPaudel's user avatar
3 votes
2 answers
8k views

Temperature compensation in transistor current cource

I am working with analysis of BJT current source. I didn't get the explanation of temperature compensation in NPN transistor with PNP and pull up resistor. How does it work actually?
vaibhav's user avatar
  • 33
2 votes
1 answer
771 views

Implementing an Avalanche Photo Diode Circuit

I am working on a circuit that will make low light measurements in the visible range. The measurements will be of biological samples that are fluorescing. For this application an Avalanche Photo Diode ...
EasyOhm's user avatar
  • 4,729
-1 votes
1 answer
717 views

Temperature compensation accelerometer and cross axis sensitivity calibration

I'm trying to compensate a 3-axis MEMS accelerometer for temperature. I can access a climate chamber where the device can be rotated in ONE axis. There is another place where I can rotate two axis, ...
Jan's user avatar
  • 131