i am trying to transmit a Ethernet frame from fpga to pc. my udp frame is:

constant udp_frameB :frame60:=
(x"FF",x"FF",x"FF",x"FF", -- mac dest
x"FF",x"FF",x"00",x"00",
x"00",x"04",x"14",x"13", -- mac src
x"08",x"00",x"45",x"00", -- IP header
x"00",x"2E",x"00",x"00",
x"00",x"00",x"40",x"11",
x"7A",x"C0",x"00",x"00", -- IP src
x"00",x"00",x"FF",x"FF", -- IP dest
x"FF",x"FF",x"00",x"00", -- port src
x"50",x"DA",x"00",x"12",-- port dest + len
x"00",x"00",x"42",x"42", -- checksum udp + data "B"
x"42",x"42",x"42",x"42",
x"42",x"42",x"42",x"42",
x"42",x"42",x"42",x"42",
x"42",x"42",x"42",x"42");

for the above frame i have calculated the FCS using the crc-32.

polynomial-X"04C11DB7".

FCS is-X"D96F0BBF"

I have adopted following method to calculate FCS:

IEEE 802.3 defines the polynomial M(x) as the destination address, source address,length/type, and data of a frame, with the first 32-bits complemented. The result of CRC is complemented, and the result is the IEEE 802.3 32-bit CRC,referred to as the Frame Check Sequence (FCS) field. The FCS is appended to the end of the Ethernet frame, and is transmitted highest order bit first (x31, x30,…, x1, x0).

please tell me ,Is FCS correct or not?

and also tell me that if the FCS is not correct then will wireshark capture it or not?