Skip to main content
1 of 2
Fry
  • 195
  • 6

Are Gerber inner layers interchangeable with regard to the stack?

Regarding the Gerber files of a 4 layer PCB with 2 inner layers:

  • Top layer: Analog signals
  • Inner layer 1: Digital signals (SPI and I2C)
  • Inner layer 2: Power planes (+3.3V and +12V)
  • Bottom layer: GND plane

For better isolation between analogue and digital signals and to prevent digital noise from coupling back into analog signals, I would like to swap the two inner layers, so that there is a power layer between analogue and digital.

Unfortunately, my EDA software (KiCAD) does not permit to reorder the stack.

This is why I'm wondering if it would be possible to simply rename the two Gerber files before sending them to the producer, so that the layer get swaped?

My guess is that the layers are only connected through vias and PTH's for THT components. Am I missing something here, that might break the PCB, if I manually swap the layers by file rename ?

Fry
  • 195
  • 6