All Questions
8 questions
1
vote
2
answers
549
views
Non-inverting switching 24 V with 3.3 V signal using a MOSFET
We have a reset circuit used in a peak-hold amplifier. Under normal conditions, a capacitor on the peak-hold circuit is grounded by RST1 (see circuit).
P0-0 is a fixed 24 V voltage from the supply.
...
- 133
0
votes
2
answers
265
views
splitting ground plane
I have a 4 layer board, where I have a 3.3V STM32 and some 3.3V components, and also a 24V H bridge to drive a 24V DC motor. The board is supplied with a 24V DC power supply, the 3.3V is created by a ...
- 297
1
vote
1
answer
223
views
Diode OR or transistor OR circuit?
I need a circuit that converts a 3.3V signal into a 24V signal. But I also need to be able to activate the 24V signal using a PCB switch. I can do it in two ways, using a diode OR or using a ...
- 265
1
vote
0
answers
40
views
Send a 60Hz trig signal over a 9m cable
I want to send a trig signal over a 9m cable, the signal is around 60Hz (each 15ms it sends a 1ms pulse). In order to avoid electrical interference I convert the 3.3V original signal with the ...
- 265
0
votes
1
answer
535
views
Interface 24V signal from one device to 3.3V signal on another device
I have a device A that sends a signal through an optocoupler, this signal travels through a 7m cable and is used by another device B that has a SN74LVC1G17SingleSchmitt-TriggerBuffer powered by 3.3V, ...
- 265
1
vote
1
answer
550
views
Using ESP8266 to read digital input pin to be notified when motion is detected from 24VDC source device
Software developer here, trying to mess around with hardware (VERY NOVICE) and implement neat things around the house using ESP8266s and Arduinos.
I have a commercial wall plug that is activated when ...
- 105
0
votes
2
answers
218
views
Trigger distant camera using 3.3V
I need to trigger a camera using a 3.3V signal, the camera is at the end of a 3 meter cable. This camera has two trigger inputs, a 3.3V GPIO input and an optocoupler input with max input of 30V. I ...
- 265
2
votes
1
answer
2k
views
Wide voltage range input regulation (24V - 3.3V)
TL; DR: I need a circuit capable of handling input voltages from 24V to 3.3V (with a 10mA/5mA maximum current) and delivering 3.3V to the microcontroller (ESP32) input.
Recently, I've been working ...
- 113