0
\$\begingroup\$

I encountered a problem while trying to flash my PCA10040 nrf52 development kit.

I am able to compile my code in Segger Embedded Studio without a problem. The chip has 512kB of flash and 24kB which should be more than enough to flash the chip.

enter image description here

Then I start flashing and I get this error message:

enter image description here

When I look at the log I see this:

enter image description here

If someone can help I would greatly appreciate it. I am open to provide with more information if something is missing.

\$\endgroup\$
2
  • 2
    \$\begingroup\$ Not sure if you are aware, but Nordic have their own support forum (devzone.nordicsemi.com) which might provide more taylored answers if you don't get the answer you are looking for here. \$\endgroup\$
    – Tom Carpenter
    Commented Dec 10, 2021 at 1:03
  • \$\begingroup\$ Thank you sir, I will try there too! \$\endgroup\$
    – DRF
    Commented Dec 10, 2021 at 14:24

0

Reset to default

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.