All Questions
Tagged with capacitive load
9 questions
0
votes
1
answer
113
views
High voltage pad buffer design with 2nF load and ringing on first stage output
I am trying to design a high voltage (12V) buffer that will drive a sine wave with rail-to-rail peak-to-peak amplitude and a big capacitive load, maybe 3nF.
Browsing I came upon this Master's project: ...
- 85
0
votes
0
answers
350
views
Capacitive load in inverter
I'm trying to understand the effect of a capacitive load at the output of an inverter.
And how does it affect the output signal when this capacitive load is high and when it is low?
Could anybody ...
13
votes
6
answers
15k
views
What is capacitive loading? (Intuitive understanding)
I have read about capacitive loading, but what does it actually mean intuitively?
I just asked this question so as to get an intuitive answer and also know what should I understand when one says that ...
user220456
0
votes
0
answers
294
views
Driving Capacitive Load
I did a bistable multivibrator drive NPN mosfet using timer55 and my mosfet drive power LED. Our Load has 3 circuit stage which are emc filter + smps circuit + power Led. I have a problem at that time ...
- 99
0
votes
0
answers
71
views
How to prevent capacitive discharge on my load after MOSFET off state
I built a button on off latch circuit using nand Gates then connected latched output to Nmosfet's gate with a resistor. My load is a smps circuit drives the power Led and this circuit has emc filter ...
- 99
1
vote
0
answers
134
views
Does a Microcontroller act as a Capacitive load or resistive?
I'm designing a unity gain buffer (IC MCP6002) and in the datasheet, it says that a small series resistor is required at the output, if the load is capacitive and is >100pF.
The input of the buffer ...
- 175
6
votes
2
answers
1k
views
Help understanding/selecting SMPS to drive capacitive load
I recently bought several SMPS buck converter supplies for a project. They all had about the same specs, typically 90-270VAC input, 12VDC output. Having an expected worst case continuous load of about ...
- 3,303
4
votes
4
answers
35k
views
Given a load, how do you calculate whether it is capacitive or inductive?
If the impedance at the load has the form of \$Z = R + jX\$, where \$R\$ and \$X\$ are positive real numbers, then then network is called inductive. If \$Z = R - jX\$, then the network is called ...
- 1,526
0
votes
1
answer
921
views
Capacitive load at the output for analysis of CMOS cells
This question is very rudimentary one. Please point me to the link if this question has been already asked.
In general, when working with simulations and and analyzing the standard cells designed ...
- 94