Skip to main content
LorenzoDonati4Ukraine-OnStrike's user avatar
LorenzoDonati4Ukraine-OnStrike's user avatar
LorenzoDonati4Ukraine-OnStrike's user avatar
LorenzoDonati4Ukraine-OnStrike
  • Member for 11 years, 2 months
  • Last seen this week
  • South Tyrol, Italy
116 votes
Accepted

Why can't I light a LED with a 1.5 V battery?

50 votes
Accepted

Is circuit design based on min/max values good practice?

39 votes
Accepted

Why do we need the "nop" I.e. No operation instruction in microprocessor 8085?

38 votes

Why can I use P = I²R but not P=V²/R when calculating energy lost in a circuit?

33 votes
Accepted

How to view and customize beta of a transistor in LTspice

30 votes
Accepted

Can a transformer work if the core is not circular?

28 votes

Why do we use 32.768 kHz crystals in most circuits?

25 votes
Accepted

Can I cut an IC?

23 votes
Accepted

What breadboard simulation software is this?

22 votes
Accepted

How do LEDs slowly degrade in normal use?

21 votes

Should there really be 1 MΩ resistance between an anti-static wrist strap and a pc?

21 votes
Accepted

Why is a capacitor used to protect CMOS chips?

21 votes

1.5V-rated MOSFET doesn't react to a gate input of 1.8V

21 votes

Does this mechanical switch really have no bounce?

20 votes

Should I take Ohm's law for granted?

20 votes
Accepted

What happens if clock cycle is replaced with constant high voltage in a processor?

20 votes

Why are relays still used in electric ovens?

20 votes
Accepted

LTspice sinusoidal voltage source with offset much larger than amplitude broken?

19 votes
Accepted

Can a Zener diode that protects a switch against inductance when the switch opens, affect turn on speed of the valve when you close it again?

17 votes
Accepted

How can I model a relay in LTSpice IV?

17 votes

Why is a capacitor considered a short circuit at start up?

17 votes

Why do motor drives have multiple bus capacitors of small value capacitance instead of a single bus capacitor of large value?

17 votes

What is "drive voltage" for a MOSFET?

16 votes

Purpose of Zener diode in button

16 votes

Does current flow on an open transmission line?

15 votes

Can I break a radio tranceiving device by operating it with no antenna connected?

15 votes

What exactly happens to the signals hitting a common mode choke?

15 votes

The mysterious case of the random leakage current

15 votes

Is MOSFET active device?

15 votes

According to my understanding, this induction heater should be melted, but it's not. Why not?

1
2 3 4 5
15